Fault Analysis of Band Saw Machine
Release time:
2024-04-24
The band sawing machine may encounter a variety of faults during use, including band saw blade fracture, screeching sound, workpiece saw bevel, etc. The causes and treatment methods of these failures are different. The following will introduce some common failures and their treatment methods in detail:
| Problem Description | reasons and treatment methods | ||
| semi-automatic model | |||
| The cause of the problem | Judgment basis | Solution | |
| 1. The saw frame does not rise | Sawing machine power line reverse connection | Press the saw wheel to see if the saw wheel rotates clockwise, The correct way to rotate is counterclockwise |
Three wires, two power cords can be arbitrarily selected to exchange positions |
| Too little hydraulic oil | Open the hydraulic reservoir and check the fluid quantity. | Fill up the fuel required by the model. (Anti-wear Hydraulic Fluid #46) |
|
| Pump air intake | Turn on the power, press the clamp and release in rapid succession Repeat operation for 30 seconds |
||
| 2. The material will not rise after sawing | The lower limit switch is not in the right position. | Touch the lower limit switch with a screwdriver, if the saw frame The rise means that the lower limit switch is not adjusted properly. |
Lower limit switch up |
| 3. The material rises without cutting off | Lower the lower limit switch a little bit, do not saw the wheel. Turn, press down directly to see if the saw frame meets the lower limit. Will the position switch rise before |
Lower the lower limit switch downward. | |
| 4. Discontinuous operation of saw wheel | The jaws are not clamped | Press the jaw to clamp, the material must be clamped before continuous operation | |
| 5. There is no cutting fluid when sawing | Not enough cutting fluid | Open the water tank and check the water line. | Fill up the coolant to the bottom of the water pump 10mm |
| Cutting fluid valve not open | Look directly at the valve switch | Open the valve switch | |
| Pipe folding | Check whether the water pipe is folded | smooth the pipe | |
Jiangsu Lichi SAW
Contact: Mr. Lu 86-13951311115
Telephone:86-513-85562688 86-513-85569902
E-mail:1793361753@qq.com
Website: www.jslcjc.com
Address: 350 Chenggang Road, Nantong City
Liyi SAW
Contact: Zhang Jianwei 86-13884380088
E-mail:liyisawco@gmail.com
Address: No. 539-19 Chenggang Road, Chongchuan District, Nantong City, Jiangsu Province
Jiangsu Sakoside
Contact: Wu Mingchun 86-15380568795
Telephone:86-513-85562688
E-mail:jsscdsksd@163.com
Website: www.jsksd.com
Address: 539-19 Chenggang Road, Nantong City
Website QR code