Safety Operation Regulation of Metal Band Sawing Machine

Release time:

2013-02-20

A: Before work (1) Before work, protective equipment should be worn according to regulations, cuffs should be tied, and scarves are not allowed. Female workers should wear work caps and put their hair into the caps. Gloves are not allowed during operation. (2) Adjust the guide arm along the dovetail guide rail according to the size of the workpiece to be processed, and lock the guide device after adjustment. (3) The maximum diameter of the saw material shall not exceed its provisions and the workpiece shall be clamped firmly. (4) band saw blade tightness should be appropriate, speed and feed must be appropriate, saw before the test run idle 3 to 5 minutes, in order to empty the gas in the cylinder, and check whether the saw machine fault, lubricating oil is normal. (5) The adjustment of the chip removal wire brush should make the wire contact the teeth of the band saw blade, but not beyond the root of the teeth. Pay attention to observe whether the wire brush can remove iron filings. II: When working (1) The saw blade is broken during cutting. After replacing the new saw blade, the workpiece must be turned over and sawed again. The saw bow should be lowered slowly and no impact is allowed. (2) cast iron, copper, aluminum parts without cutting fluid, other need to add cutting fluid. (3) When sawing pipes or sheet profiles, the pitch should not be less than the thickness of the material. When sawing, the handle should be retracted to a slow position and the amount of feed should be reduced. (4) When multi-body sawing, a reasonable number of saws should be selected to ensure that each is in a clamped state, and the sawn material should be cleared from the band saw in time. (5) Stick to your post and observe any abnormality at any time. Pick up the saw frame or stop the car in time. (6) usually add enough lubricating oil, replace the lubricating oil in the gear box every year, and cover the guide rail and processing surface with oil when idle to prevent rust. (7) When the material is about to be sawed off, strengthen observation and pay attention to safe operation. (8) When changing the shifting position, the machine must be stopped first. Three: after work (1) After the end of the work, stop the operation of the machine tool, put the various tools used in the toolbox in an orderly manner, and place the finished products and products to be processed in the corresponding areas. (2) Daily maintenance shall be carried out on the machine tool, and spot check records shall be made in the Spot Check Table of Machine Tool. (3) Clean up the iron filings and residual materials near the working area. (4) Cut off power supply equipment such as machine tools, lighting and electric fans.