Safety Operation Regulation of Horizontal Band Saw Machine
Release time:
2013-02-20
1, should check before processing: a, saw wheel running direction is correct. B, band saw tension is appropriate. C, whether the system pressure is sufficient. 2. According to the specifications of the material to be cut, the material should be reasonably selected: a. The tooth pitch of the saw belt. B, the appropriate amount of cutting. C, and adjust the position of the guide arm and the position of the rotary shaft end of the saw frame. 3. Test run empty first to check whether the operation is stable, whether the clamping device is reliable, whether there is noise, whether the saw band is vertical, and whether the saw frame swings. 4. When processing, strictly follow the procedure and adjust the cutting dosage according to the cutting situation. 5. A reasonable number of roots should be selected during multi-body cutting to ensure that each root is in a clamped state and the sawn material is cleared from the band saw in time. 6, stick to the post at any time to observe the abnormal timely pick up the saw frame or stop the car. 7. Remove the chips in the worktable and saw wheel box in time, and check the cleanliness and oil quantity of coolant and hydraulic oil frequently. 8, usually add enough lubricating oil, replace the lubricating oil in the wheel box every year, and add oil seal to the guide rail and processing surface when idle. 9. After the work, clean the sawing machine, add lubricating oil and cut off the power supply.
1, should check before processing: a, saw wheel running direction is correct. B, band saw tension is appropriate. C, whether the system pressure is sufficient.
2. According to the specifications of the material to be cut, the material should be reasonably selected: a. The tooth pitch of the saw belt. B, the appropriate amount of cutting. C, and adjust the position of the guide arm and the position of the rotary shaft end of the saw frame.
3. Test run empty first to check whether the operation is stable, whether the clamping device is reliable, whether there is noise, whether the saw band is vertical, and whether the saw frame swings.
4. When processing, strictly follow the procedure and adjust the cutting dosage according to the cutting situation.
5. A reasonable number of roots should be selected during multi-body cutting to ensure that each root is in a clamped state and the sawn material is cleared from the band saw in time.
6, stick to the post at any time to observe the abnormal timely pick up the saw frame or stop the car.
7. Remove the chips in the worktable and saw wheel box in time, and check the cleanliness and oil quantity of coolant and hydraulic oil frequently.
8, usually add enough lubricating oil, replace the lubricating oil in the wheel box every year, and add oil seal to the guide rail and processing surface when idle.
9. After the work, clean the sawing machine, add lubricating oil and cut off the power supply.
Jiangsu Lichi SAW
Contact: Mr. Lu 86-13951311115
Telephone:86-513-85562688 86-513-85569902
E-mail:1793361753@qq.com
Website: www.jslcjc.com
Address: 350 Chenggang Road, Nantong City
Liyi SAW
Contact: Zhang Jianwei 86-13884380088
E-mail:liyisawco@gmail.com
Address: No. 539-19 Chenggang Road, Chongchuan District, Nantong City, Jiangsu Province
Jiangsu Sakoside
Contact: Wu Mingchun 86-15380568795
Telephone:86-513-85562688
E-mail:jsscdsksd@163.com
Website: www.jsksd.com
Address: 539-19 Chenggang Road, Nantong City
Website QR code